![]() ![]() I think it must be something else, we have the parts book and everything seems to be going together corectlly. John 310C Backhoe/Loader, Hrs Showing, 75 Hp, 4 Cylinder JD Diesel Engine, 4 Speed Shuttle Shift Transmission, Joystick Loader Control, 91 Front Loader Bucket. We go out the third day and it will not move forward or reverse:Banghead we have 4500.00 in parts and labor. We go buy a used reverser and put it in and it goes forward but will not go backward:Banghead we pull it and the clutches are worn and plates are busted, we tak the new clucthes out od the orginal one and put in the used one and put it back together, it works for 2 days. We had the plantary gear installed by the dealer, and after getting it back it works for a few days. The JD 210C is fitted with a John Deere 4239D four-cylinder liquid-cooled diesel engine rated at 55 hp (41 kW) and a max. ![]() I pulled it out first because it woulf not go forward, found clutchs worn, replaced clutches and it works for 2 days, then same problem, pull it and find bad plantary gear, fix it then it will not go forward. The John Deere 210C backhoe loader was manufactured from 1986 to 1996. John Deere 310 Backhoe found in: Fuel Lift Pump, Fuel Injector, Eaton Power Steering Pump Seal and O-Ring Kit, Water Temperature Gauge, Ammeter (Amp) Gauge 60-0-60, 12 Volt Distributor HOT Coil (55000-Volts), Steering Wheel. Pulling the reverser is a pain in the rear to say the least. I have taken out the reverser and replaced the clutches, and plantary gear. The backhoe will not move forward or reverse.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |